Step 1
Cut out all material using the Lumber & Sheet Cut Layout Guide. Drill the holes as indicated on Page 5.
Step 2
Align the 11-1/4” side panels to the 20” back panel as shown in the diagram. Make sure the side panel with the hole is on the right. Glue and nail from the backside.
Step 3
Align the lower drawer support 2-1/2” from the bottom. Glue and nail together.
Step 4
Align the upper shelf 6-7/8” from the bottom. Attach with glue and nail together.
Step 5
Slide the other end of the 3/8” dowel into the hole on the side panel.
Step 6
Slide the other end of the dowel into the hole of the partition board. Glue and nail the partition board 9-1/2” from the ride side.
Step 7
Measure 3” from the back board as shown in the diagram. Glue the divider to the bottom and side
Step 8
Add the second partition along the divider. Glue and nail the partition to the back and bottom.
Step 9
Using the router and a 1/2” straight bit, cut a 1/4” x 1/4” rabbit into one edge of the drawer panels. The rabbit will be located at the bottom inside edge.
Step 10
Align both side panels to the drawer bottom. Glue and nail together.
Step 11
Align the front and back panels to the drawer bottom. Glue and nail together.
Step 12
Sand the cabinet and drawer.
Step 13
Add handle to the drawer.
Difficulty Level - Easy
DIY Desk Organizer
Organize all of your must-have desk essentials to start the new year off right with this Desk Organizer 📓✏️
