Step 1
Measure and mark cut lines for (2) 1"x10"x11", (1) 1"x10"x18-3/4", and (3) 1"x4"x18-3/4."
Step 2
Make the wood cuts according to the lines marked in the first step.
Step 3
On the 2 side pieces (1"x10"x11"), cut an angle by cutting along a diagonal from 5-1/2" on the side to 3-3/8" on the top on both sides.
Step 4
Sand all of the pieces of wood in preparation for staining.
Step 5
Apply stain to all of the pieces. Allow 24 hours to dry.
Step 6
Drill a 1/2" deep hole about an inch down on the inside of the (2) 1"x10"x11" side pieces using a 1" Bit
Step 7
Construct the base by attaching the (3) 1"x4"x18-3/4" divider pieces on top of the 1"x10"x18-3/4" bottom piece. Attach one of the dividers in the middle of the bottom piece, then attach the other two on the front and back of the bottom piece
Step 8
Line up the two side pieces with the sides of the base. Line up the dowel where the circles have been made. Measure out the length between the two sides and cut to size.
Step 9
Line up the two sides with the base and insert the dowel into each circle. Nail each piece into place
Step 10
Attach the bottle opener on one of the sides of the caddy using the included screws.
Step 11
Apply the polyurethane all over the BBQ Caddy to seal the stain. Allow at least 24 hours to cure.
Difficulty Level - Intermediate
BBQ Caddy
Carry all of your BBQ essentials with this DIY BBQ Caddy!
