Comments (4)

• Beautiful work. The smaller the project, the more accurate it has to be. You nailed it (probably without any nails)!

  By mrpip, on September 1, 2017

• • Thank you for the comment. Your right no nails all glue. I made this for a friends daughter who is getting married at the end of this month. The finish is with 800 grit paper and 4 coats of poly urethane gloss.

    By Brentwalter, on September 1, 2017

• Where do i get the plans and instructions for this. Want to make one for my daughters wedding.

  By Nuannce, on September 2, 2017

• • I do not have plans. Just went off the dementions that the customer wanted. 16"long by 14"deep and 12" high. 45 degrees on all corners. Put the bottom on the inside of the box and then put the top on. Wants all dried I went to the table saw and cut the top off at a certain size so the hardware would fit and that was my lid. Used appropriate sand paper. Put on polyurethane gloss 4 coats and used 800 grit between coats. Hope this helps

    By Brentwalter, on September 3, 2017