I was asked to build a simple console table for a friend. I painted it with a white milk paint (I been on a milk paint kick lately). It turned out quite nicely and was an easy build. They are quite pleased with how it turned out and its a great fit for the room.
This was off my own design so I really only have the drawing that's in the last pic. But here ya go:
4-10" 1x4 (side apron and bottom supports)
3- 62" 1x4 (front and back apron and lower support)
4- 29.25" 1x4 (legs, cut at an angle of your choosing at the bottom for detail, I think mine were 5°)
2- ?" 1x4 (angled pieces, they were cut at 50° and 40° on either end, not parallel and I measured them in place after the 62" pieces were in place)
2- 6ft 1x8 (top, kreg jiged together to make it a 6ft x 14.5" top)
I used the premium pine from HD for this build, it a little more expensive but with a small material list it wasn't too bad. I made the top 6ft because the 1x8s are 6 or 8ft and I didn't have any waste on those boards.