My wife is a "scrapbooker" and needed storage for her stacks of scrapbook paper. I drew up a basic design that would hold 12"x 12" paper. Most of the build went without issues. I built the sides and bottom piece and cut all the shelf material. I then painted the inside pieces before assembly, because the spacing between the shelves would have made that difficult to do after being installed. I was planning to fasten the shelves to the brackets using my nailgun, but the spacing was too close and I ended up just gluing them in. I wanted to put a decorative edge on the top piece, so I used my cordless trim router which did a surprisingly good job. My wife is very happy with the finished product and already has it almost full.
My wife is a "scrapbooker" and needed storage for her stacks of scrapbook paper. I drew up a basic design that would hold 12"x 12" paper. Most of the build went without issues. I built the sides and bottom piece and cut all the shelf material. I then painted the inside pieces before assembly, because the spacing between the shelves would have made that difficult to do after being installed. I was planning to fasten the shelves to the brackets using my nailgun, but the spacing was too close and I ended up just gluing them in. I wanted to put a decorative edge on the top piece, so I used my cordless trim router which did a surprisingly good job. My wife is very happy with the finished product and already has it almost full.