Scrap wood incense burner
Cute little incense burners I made from pieces of broken pallet boards that were going to be thrown out. Cut to 13 inches. Cut a wedge at 45 degree angle about an inch long to hold incense. Glue your wedge to your other board on whichever side you want facing up. Drill a small hole in the wedge to hold the incense. Mark your board where you the ashes will fall and use a router to make a groove there. Sand, then paint or stain!
Comments (0) Sign In To Follow Project
paint or stain
piece of scrap wood 13 inches long
80 and 220 grit sand paper