This is a pallet herringbone table top I built with a custome beverage pale for game, fight, and me time. I built the bottom frame and legs with 2x4 with pocket holes and the top with pallet wood had a very hard time separating that pallet wood once I got good enough boards and ripped the edges with my 10" Ryobi table saw I was able to lay out my design on a 60"L piece of 1/4" ply gathering the pieces to match as I didn't use a thickness planner next time I definitely will use one once I got them close enough I hand planned the joints made some brackets with pallet scraps to hold the pale in place and cut the hole in the middle of the table carefully trying not to break the boards as I cut, i used the board to glue on the cover to match the design of the herringbone. After I stained and used polyurethane sanded inbetween coats with my Ryobi 1/4" sander. My intentions for the code table were to have enough space food snacks nachos to eat as well as have a beverage pale to fill up with ice and add my beverage of choice to it and for gatherings keep an ice cold drink ready at hands reach and not have to constantly get up and get in people's way while watching a game, or fight I think it came out perfect for my needs and using it is always a pleasure and once I pop the cover off everyone is amazed by it one thing I will do different next time is use a 4x4 square leg style and use a thickness planner so all boards are perfectly even. Thanks for viewing and can't wait to build another one!