Comments (4)

• Great job! do you have plans and or pictures of project in phases? I'd love to build one

  By bikegiant1, on January 5, 2017

• • Bikegiant1, Sorry but I built this from a picture my wife found in a magazine. I will get some measurements and some more pictures for you in a couple of days. Thanks for your comment.

    By Golfstarter, on January 5, 2017

  • Bikegiant, the center is 21 1/2" deep x 58" wide x 31" tall. The cabinet doors are 18" wide x 24" tall. All black hardware is made fro, 1 1/2" aluminum bar stock, bent and painted. What I would do different....I found the height is determined by the height of the sliding doors since you must allow for the doors plus the hardware. To make the hardware that hangs the doors, I tried to put 2 90 degree bends but kept braking the bar. My solution was two pieces, the one in front that attaches to the door and one in the back that the bolt feeds into. The two pieces are pop riveted at the top. The wheels are from a laundry line pulley and I used several washers to get them to run true. It does not show in the pictures but I saved the glass door from the old cheap TV stand and installed it in the center. I have taken some close-up pictures of the hardware but can't figure out how to upload them. Hope this helps.

    By Golfstarter, on January 6, 2017

• Thank You very much !!!!

  By bikegiant1, on January 6, 2017