Measure and make cuts from the cut list using your circular saw:
(1) 11-3/4" x 11-3/4" piece plywood
(2) 29-1/2" (1x2x10)
(12) 10-1/4" (1x2x10)
Lay (1) 29-1/2" piece on its side. Using wood glue, attach (2) 10-1/4" pieces, one to the top, and one to the bottom, as if you are creating a frame. Use wood glue to attach (4) more 10 1/4" pieces in the middle of the 29-1/2" piece, evenly spaced from each other. Let dry for a few minutes.
Apply wood glue to the ends of the 6 pieces, and attach the second 29 1/2" piece. This will look like a ladder. Let dry for a few minutes.
Drill pilot holes into each rung, and fasten with wood screws
Next, you'll create the bottom frame: Take (1) 10 1/4" piece, and use wood glue to attach (2) 10 1/4" pieces, to either end, on the inside of the top piece. Drill a pilot hole from above into each side, then fasten together using wood screws
REPEAT the above step to create the TOP Frame
Apply wood glue to the outward facing ends of the frame, and slide into place at the bottom of the ladder.
Drill a pilot hole on either side where you attached the frame, and fasten with wood screws.
Now attach the table top panel. Apply wood glue to the top frame, and secure tabletop by drilling pilot holes and fastening screws.
Apply wood filler to all exposed screws, and use your orbital sander to remove excess, dried wood filler.
Finish to your heart's desire, and enjoy!