INDUSTRIAL PLATE RACK
Create this trendy industrial looking shelf to display your plates and platters. This is a great project for beginners and functions not only as a piece of furniture but a great piece for wall decor and it is easy to modify the size to fit any space.
Measure and cut as you go. Cut 2 pieces of 1x2 @ 30". Apply a thin line of glue to each 1x2. I used my Airstrike Nailer to attach a piece at each short end of the plywood. Make the back of the plywood flush with the back of the 1x2 so that there is a 3/4" over hang on the front.
I used my Ryobi 10" saw to make the cuts on this piece!
Cut 5 - 2x6 boards at 30" and apply a thin line of glue to each board before attaching.
To set them temporarily, I used my Airstrike Nailer to put a few nails through the 1x2 trim into each end of the shelves. I placed my shelves 13" from each other, based on the plates and platters that I wanted to display.
Flip the piece over, on it's side, and drive 3 - 3” wood screws into each shelf, through the back of the piece.
I screwed one elbow into each floor flange and then attached the pipe in between. I made on of these for each shelf. To attach the pipes, I used #12 x 5/8" screws and used my Ryobi 18-Volt drill to secure them.
Comments (0) Sign In To Follow Project
1 - 3/4" sheet of Purebond plywood
1x2 @ 8ft.
2 - 2x6 @ 8ft.
10 - Galvanized floor flanges
10 - Galvanized 90 degree street elbows
5 - 24" (1/2" thick) galvanized pipes
40 #12 x 5/8” screws
15 - 3” wood screws