Hello and thanks for your comments. I routinely use a blower and broom to sweep my garage but the biggest way I keep it clean is that I do not usually cut wood, etc.. in it. My garage is used for storing two cars, three kayaks, my 18V cordless tools and my exercise equipment. I use my basement shop for my work. Its organized but does not stay as clean :)
Hello Kasey, Glad you like the photo. My wife and I went to Banff Canada in May 2018 and had this picture taken. It was at Lake Moraine and I highly recommend going there! The lake was just thawing and in the summer months, you can canoe on the lake. Other beautiful areas are Lake Louise, Johnston Canyon and Emerald Lake.
JNash703, I did forget one thing. You will notice a 45 Degree notch on the back trim pieces. This makes it easier to mount as you will need to angle the shelf to approximately 45 Degrees to mount the "L" Screw into the PegBoard.
Hello JNash703. I do not have any formal plans but will go over my build. For the Shelf and supporting wall brace, I use Weaber 1/2" X 6" X 3' poplar boards purchased at Home Depot (Model# 27369). I cut the size about .5 inches larger than my tool (Sides and Depth) and then cut wall support the same width and 3" long.
Place a bead of Wood Glue along back edge of shelf and adhere to edge of wall support as it will form an "L" shape. I then cut some shelf brackets for support using the same Weaber board. My supports are .5" wide and I cut a 45 degree angle on top and bottom. Wood Glue the angled brackets to the underside of the shelf and back wall support.
For the trim around the shelf, I use Weaber Poplar boards sized at .25" Thick X 1.5" Wide. Cut to fit around the sides and front of the shelf and Wood Glue them to the edges of the shelf.
To hang the shelf, I use "L" screws purchased at Home Depot. (Drill a pilot home for them and space them apart even whole number intervals such as 4, 5, or 6 inches) Thread in the screws and you should be ready to mount.
For lighter accessories, I was able to get by with just the Wood Glue, but used Brad Nails / Small Screws with the glue for heavier items such as my Jig Saw. (Note: Did not have to use Screws / Nails on the brackets or trim, just attaching shelf to wall support).
I hope this helps and I was thinking of laying out the materials and snap some pics if needed. Just let me know.