EDGE BAND & CUT HOLE:
Iron on edge banding, all sides of top and bottom and short
sides of smaller boards.
Place a nail or screw at center of circle. Then, string and
pencil draw a 15-1/4” diameter circle (7-5/8” radius).
Then, drill a large hole within that circle and cut off with
a jig saw.
Mark a line with a pencil center of center divider to assure
nails are placed properly.
Assemble box using wood glue and 1-1/4” screws (pre-drill
holes using 7/64” drill bit) or use brad nails (not all shown).
Sand out any rough spots or edges before painting/staining
Finish box and legs as desired with primer & paint, stain, or
a combination of the two!
INSTALL TOP PLATE & LEGS:
Locate dual top plate, 45 degrees and corners 3/4” from
edges and install using 3/4” wood screws.
Install 7-1/2” tapered legs on top plate as desired (straight